Yourpressurewasherrequiressomeassemblyandis readyfor useonlyafterit hasbeenproperlyserviced withtherecommendedoilandfuel.
If you have any problems with the assembly of your pressure washer, please call the pressure washer helpline at
IMPORTANT: Any attempt to run the engine before it has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER FROM CARTON
1, Slice two corners opposite guide handle end of
carton from top to bottom so panel can be folded down flat.
2, Remove fillers, accesories and parts bag shipped with your pressure washer.
3.Roll _ressure washer out open end of carton.
4.Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call the pressure washer helpline at
1-800-222-3136. Main Unit Handle
Plastic Accessory Tray
High Pressure Hose
Spray Gun
Hose Reel
Turbo Nozzle with Quick Connect Fitting
Nozzle Extension with Quick Connect Fitting and Spray Tip Holder
Oil Bottle
Parts Bag (which includes the following):
Owner's Manual
Owner's Registration Card
Bag containing 4
Handle Fastening Hardware Kit (which includes): Carriage Bolt
++LBolt
Plastic Knobs (2) ++J'Hook
Chemical Hose Clip
Self Tapping Screws (4)
Become familiar with each piece before assembling the pressure washer. Check all contents against the illustration on page 5. If any parts are missing or damaged, call the pressure washer helpline at
ASSEMBLING YOUR PRESSURE WASHER
Your Craftsman high pressure washer was mostly assembled at the factory. However, you will need to perform these tasks before you can operate your pressure washer:
1.Fill out and send in registration card.
2.Attach accessory tray to handle, then attach handle to main unit.
3.Add oil to engine crankcase.
4.Add fuel to fuel tank.
5.Connect high pressure hose to spray gun and pump.
6.Connect water supply to pump.
7.Attach nozzle extension to spray gun.
8.Select/attach quick connect spray tip to nozzle extension.
9.Attach hose reel according to instruction sheet included in hose reel box.
Attach Handle and Accessory Tray
NOTE: All assembly operations given in this section will be described from the perspective of assembling the pressure washer from the rear.
1.Slide plastic accessory tray onto handle and align holes in accessory tray with holes on handle.
/
2.Secure tray to handle with self tapping screws using a #2 phillips screwdriver. Ensure screws are tight but not crushing the plastic accessory tray.
3.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle
align with holes on handle supports.
6
