AFTER EACH USE
Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on pump parts and "freeze" pump action. Follow these procedures after every use:
1.Flush detergent siphoning tube by placing the filter into a pail of clean water while running pressure washer in low pressure mode. Flush for one to two minutes.
2.Shut off engine, let it cool, then remove all hoses.
3.Disconnect spark plug wire from spark plug.
4.Empty pump of all liquids by pulling recoil handle about 6 times. This should remove most liquid in pump.
5.If storing for more than 30 days see "Long Term Storage" on next page.
6.Coil high pressure hose and inspect it for damage. Cuts in hose or fraying could result in leaks and loss of pressure. Should any damage be found, replace hose. DO NOT attempt to repair a damaged hose. Replace hose with genuine Sears part.
7.Disconnect hose from spray gun and high pressure outlet on pump. Drain water from hose,
gun, and nozzle extension. Use a rag to wipe off hose.
8.Slide one end of hose into hole on hose reel. Turn hose reel with handle to coil hose onto reel.
9.Reconnect spark plug wire to spark plug.
10.Store unit in a clean, dry area.
_ | WARNING] NEVER | the engine | with fuel |
| in the gas tank indoorsstorein enclosed, | poorly | |
ventilated areas where fumes may reach an open flame, a spark, or pilot light.
WINTER STORAGE
Freeze damage is not covered under warranty
To protect the unit from freezing temperatures:
1.Flush detergent siphoning tube by placing filter into a pail of clean water while running pressure washer in low pressure mode. Flush for one to two minutes.
2.Empty pump of all pumped liquids by pulling recoil handle about 6 times. This should remove most
liquid in pump.
3.Use pump saver, available at Sears retail item
4.If pump saver is not available, connect a
hose.
16
