Yamaha YSP-1100 35 En, Error messages for Auto Setup, Before the Auto Setup procedure starts

AUTO SETUP (IntelliBeam)

■Error messages for AUTO SETUP

Before the AUTO SETUP procedure starts

Error message	Cause	Remedy	See
			page
ERROR E-2	The optimizer microphone is not	Connect the optimizer microphone to	30
No MIC Detected. Please check	connected to this unit.	this unit.
MIC connection and re-try.

While the AUTO SETUP procedure is in progress

If one of the errors shown below except E-1 is displayed, press RETURN. In case you have started the AUTO SETUP procedure by pressing AUTO SETUP on the remote control in step 3, run the procedure again from step 3 after once the screen disappears. In case you have started the AUTO SETUP procedure by pressing MENU on the remote control in step 3, run the procedure again from step 5 after the screen in step 4 is displayed. Run the MANUAL SETUP if the problem is difficult to be saved.

Error message	Cause	Remedy	See
			page
ERROR E-1	There is too much unwanted noise in	Make sure that your listening room is as	—
Please test in quieter environment.	your listening room.	quiet as possible. You may want to
		choose certain hours during the day
		when there is not much noise coming
		from outside.
ERROR E-2	The optimizer microphone was	Make sure that the optimizer microphone	30
No MIC detected. Please check	disconnected while the AUTO SETUP	is firmly connected to this unit.
MIC connection and re-try.	procedure was in progress.
ERROR E-3	Some other operations were performed	Do not perform any other operations	—
Unexpected control is detected.	on this unit while the AUTO SETUP	while the AUTO SETUP procedure is in
Please re-try.	procedure was in progress.	progress.
ERROR E-4	The optimizer microphone is not placed	Make sure that the optimizer microphone	30
Please check MIC position. MIC	in front of this unit.	is installed in front of this unit.
should be set in front of YSP.
ERROR E-5	The optimizer microphone is not placed	Make sure that the optimizer microphone	30
Please check MIC position. MIC	in the right distance from this unit.	is installed more than 1.8 m from the
should be set above 1.8m/6ft.		front of this unit and within 1 m from the
		center height of this unit.
ERROR E-6	The optimizer microphone cannot collect	Make sure that the optimizer microphone	30
Volume level is lower than	the sound produced by this unit because	is firmly connected to this unit and
expected. Please check MIC	the sound output level is too low.	placed in a proper location. If the
position/connection and re-try.		problem persists, contact the nearest
		YAMAHA service center for assistance.
ERROR E-7	An internal system error occurred.	Repeat the AUTO SETUP procedure.	—
Unexpected error happened.
Please re-try.

SETUP

English

35 En