PLAYBACK
Set the operation mode selector to YSP to switch to the operation mode of this unit and then press VCR on the remote control to play back a video tape.
TV/AV | VCR |
YSP |
|
VOL
Playing back sources
Once an input source is selected (see page 39), you can play back the selected input source.
Note
This section uses a DVD player as an example of the playback source.
y
For details on the TV and the DVD player you are using, refer to the owner’s manual supplied with the TV and the DVD player.
Set the operation mode selector to YSP to switch to the operation mode of this unit and then press AUX on the remote control to play back a component connected to the AUX jack on the rear panel of this unit.
TV/AV | AUX |
YSP |
|
1Turn on the power of your DVD player using the remote control supplied with the DVD player.
2Switch to the video input on your TV using the remote control supplied with the TV so that the DVD menu screen is displayed.
3If necessary, turn down the volume of your TV until you cannot hear any sound.
VOL
4Set the operation mode selector to YSP to switch to the operation mode of this unit.
TV/AV
YSP
5Press DVD on the remote control to select DVD as the input source.
DVD
6Play back the DVD on your DVD player using the supplied remote control.
Audio signals from your DVD player are output from this unit.
y
•You can check the digital signal being input at the DVD player with the digital connection (optical/coaxial). Press ST+3BEAM on the remote control while playing back a DVD recorded in 5.1
channel. The 
DIGITAL or 
indicator lights up when this unit detects the 5.1 channel signal input at the optical/
coaxial jack. If the PCM indicator lights up, confirm the digital connection and the settings of the digital output, bitstream output, and/or DTS output of the DVD player.
•If the output volume is too low, increase the volume on this unit to around 45.
•If you have set the appropriate remote control codes for your TV and DVD player, you can use the remote control supplied with this unit to operate these components. For details on how to set remote control codes, see page 81.
