BoEXTENSION CORD
1.Use only a 120 A.C. voltage supply as shown on the nameplate of the unit to power your blower.
2.The extension cord used to reach the power source must be:
a.Specifically marked as suitable for out- door use (W/k_).
b.Heavy enough to carry the current from the power source the full length of the ex- tension cord to the unit, Otherwise, loss of power and overheating can occur causing dam- age to the unit. Refer to Fig_are 8 for minimum
wire gauge recommendations. The cord must be marked with the proper wire gauge. (Appropri- ate extension cords are available.)
c.In good condition. Cord insulation must be intact with no cracks or deterioration. Plug con- hectors must be undamaged.
3.Secure extension cord to unit as follows:
a.Loop the extension cord though the cord retain- er and around the hook. Figure 9.
b.Insert cord socket into recessed plug. Figure 9.
C, OPERATING TIPS-- BLOWER
A WARNinGI
Do not use the unit as a blower without the blower [
tubes properly attached to avoid flying debms]
.an.d/or impeller contact which can cause serious ]
!
AWAR. NING
Always wear eye protectmn to prevent rocks or de-
bris from bemgblown or mcocheting into the eyes
and face which can result in blindness or other se- rious injury.
1.Always work going away from solid objects such as walls, large stones, automobiles and fences.
2.Clean corners by starting in corners and moving outward to straight areas to prevent an accumula- tion of debris which could fly into face.
II,,,H,
D. OPERATING TIPS -- VACUUM
AWARNING
Do not use the unit as a vacuum without the vacu-
um tubes and collection bag properly attached to
avoid flying debris and/or impeller contact which
can cause serious injur_ Always make sure the
collection bag is completely zipped before the unit is started.
1.When usingyour unit as a vacuum, best results are achieved when the unit is operated at full speed.
2.Move the unit slowly back and forth over de-
bris to be vacuumed. Avoid forcing the vacuum tube into a pile of debris as this can clog the unit.
3.The vacuum can pick up objects that are too
big to pass through the impeller. This type of object will fall out of the vacuum tubes when the unit is stopped.
4.If the unit becomes clogged:
iilllllllll i | i IH, | ,,, |
E_PRE-OPERATION | CHECKS | |
Before operating your unit, always:
1. e"CHECK OVER WARNINGS AND SAFETY
INSTRUCTIONS in this Operator's Manual.
Make certain you completely understand and fol- low each one.
|
| MINIMUM | WIRE | GAUGE | |||
|
| RECOMMENDATIONS |
| ||||
VOLTS | 25 | Ff. | 50 Ff. |
| 100 Fr. | ||
120 |
|
| 18 | 16 |
|
| 14 |
|
| A.W.G.* | A.W.G.* |
| A.W.G.* | ||
•_e_, | wi_c_u_, | Figure | 8 |
|
| ||
|
|
| /__.___ord |
|
| Retainer | |
Cord |
| __'2__/__i. |
|
| H°°k | ||
Socket |
| \\_ t_,,0 | _ | \ \ | ', 1 " | Recessed | |
|
|
| Figure | 9 |
|
| |
3. | Be | careful when | working | near | plants. The | ||
force of the air could damage tender plants.
4.Direct mr flow by directing the nozzle down Or to one side.
5.Vary air flow by adjusting the position of switch. Use low speed when blowing in corners, against walls, around tender plants, etc. Use high speed when blowing in open areas or when vacuuming.
6.Use the assist handle located on the side of the unit when working above the waist or when a two- handed gripis desired.
7.Uses For Your Blower:.
a.Sweeping debris or grass clippings from drive- ways, sidewalks, patios, parks, parking lots, barns, stadiums, etc.
b.Piling grass clippings, straw, or leaves.
c.Removing debris from corners, around joints, and between bricks.
a.Stop the motor and disconnect the power source. Do not attempt to remove obstructtons with the motor running.
b.Wait until the impeller has completely stopped turning, then remove the vacuum tube.
c.Carefully reach into the vacuum opening and clear out debris.
,The collection bag must be properly emptied
and maintained to avoid deterioration and obstruc-
tion of air flow which will reduce the performance of the vacuum.
a.Remove the bag from the unit. Empty after each use by turning the bag inside out and shaking out debris. Do not store bag containing leaves, grass, etc.
b.Wash the bag once a year as follows:
1)Turn the bag inside out.
2)Hang it up.
3)Thoroughly hose it down.
4)Let bag hang until dry.
. €CHECK THE UNIT FOR LOOSE BOLTS,
NUTS, OR FITTINGS. Tighten, repair, or re- place parts as necessary. Use only genuine replace-
ment parts as recommended by Sears.
