REPAIR AND ADJUSTMENT
BELT | ENGINE | IDLER BELT |
EXTENSION | PULLEY | GUIDE |
SPRING | ...._ IDLER | SHAFT |
|
| |
LH. |
| ASSEMBLY |
23. Mower Drive Belt Removal
NOTE: MOWER BELT INSTALLATION DECAL LOC- ATED ON MOWER HOUSING_
REPLACE ONLY WiTH THE BELTS SPECIFIED IN THIS
MANUAL.
f
COTTER
EXTENSION SPRING
BRAKE__
ROD
COTTER PIN
aPlaceattachmentclutchlever in"Disengaged"posi- tion (Fig 30)
b,, Move Attachmentliltle_er (Fig 30).forwardto lower mower to its lowest position_
c_ Roll belt off engine pulley_
d,. Pull belt off both mower deck pulleys._
e._ Springbelt guideaway from idlerpulley and pullbelt off idler pulley
LSlide belt from under extensionspring.
24.Mower Drive Belt Replacement
a,. Slide belt under extension spring(Fig. 33)_
b,_ Place belt on rear side o! both mandrel pulleys
c,. Sprin_ idler belt guide down and place belt around rear s_deo! idler pulley
d.Roll belt over engine pulley
e.Make sure belt is inside all belt guides,,
LH. PIVOT
R,H. PIVOT
BRACKET'
FIGURE 33
LIR'
LEVER
BOTTOM | E_ | BOTTOM |
OF CURL |
| OF CURL |
LINE
FIGURE 34
__ |
| NUT "C" |
SIDE TO | / |
|
ADJUSTMENT | _ i | NUT "B" |
TRUNNION _
J
FIGURE 35
NOTE: WHEN INSTALLING A NEW BELT, EXTENSION SPRING MUST BE RETURNED TO LOWER END
OF SLOT (ORIGINAL POSITION) ON ROCK SHAFT ASSEM BLY.
25= Mower Drive Belt Adjustment
Yourtractorhas been manufactured withthe abilityto read- justthe rnowerdrive belt to provideyouwith longer belt life,,
If the attachment clutch lever travels
justment is necessary, NOTE; CHECK FOR PROPER SPRING TENSION WITH THE ENGINE OFF AND THE
LIFT LEVER IN THE HIGHEST POSITION.
aLower the mower deck for easier access,.
bUsing (2) 7/16"wrenches, removethe bolt, nut & D- Shaped washers (Fig 33- inset).
c.Move extension spring from lower end of slot to up- per end in rockshaft assembly and install bolt, nut & the
dTighten bolt and nut to secure the
26.Level Mower Housing
Adjustthe mower while tractor is parkedon level ground or driveway. Make sure tire pressure is correct, fl tires are over or under inflated, you will not properly adjust your mower..
a.Depress lift lever plunger and use lift lever to raise mower to maximum cutting height (Fig. 31),
b.Measure heightfrom bottomof cudto groundline at front of mower. Distance"A" shouldbe the same on both sides (Fig, 34),
c.If distance "A"needs to be changed, snap out ac- cess hole cover on L.H, side above footresL Use 11/16" wrench on nuts "B" and "C" at
d.To raise left side of mower, loosen nut "B" and tighten nut _C",
eTo lower left side of mower, loosen nut "C" and tighten nut "B"..
22