TROUBLE SHOOTING
NO UGHTS
WON'TCHARGE
ENGINE WILL NOT SHUT DOWN
WHEN OPERATOR LEAVES SEAT
UNSATISFACTORY MOWER PERFORMANCE UNEVEN DISTRIBUTION OF CUPPINGS
MOWER BLADES WILL NOT ROTATE
EXCESSIVE MOWER VIBRATION
WINDROWING STRIPPING OR DROPPING OF GRASS CLIPPINGS
UNEVEN CUT OR SCALPING
mP | Use fresh fuel and adjust Carburetor |
| |
| Drain and replace oil for propertemperature |
_r | Check Fuse, Switch and Wire Connections_Replace Headlight Bulbs |
| Replace Switch |
aP | Check Fuse for fault and replace |
| Replace Battery |
_P | Replace Regulator |
_P | Replace Alternator |
| NOTE: This tractor is equipped with an operator presence sensing |
| system..Any attempt by the operator to leave the seat wi!h the engine |
| funningand the mower clutch engaged will shut down the engine. |
w.Check all Wire connections Check Seat Switch
Check Operator Presence Relay
Place Throttle Control in "FAST" position Check air pressure in Tires
Check
Replace Mower Blades
=_ Reinstall Mower Blades with Sharp Edge down ,=" Replace with proper Mower Blades
Readjust Mower Drive Belt
=r Clean undersideof Mower Deck Correct Clutch mechanism interference
,=," Install new Mower Drive Belt =r Adjust Mower Drive Belt =_" Replace frozen Mandrel
=r Replace frozen Idler Pulley
_" Replace bent or unbalanced Blades ==" Replace Mandrel Replace Deck
,=- Set Throttle for maximum engine speed =r Let grass dry out
Clean underside of Mower Deck
==," Readjust Mower
Replace Blades
Readjust Mower
Replace bent Mandrel(s)
.....................................................................iii
26