SERVICE A D ADJUSTMENTS
TO ADJUST STEERING WHEEL ALIGNMENT
if steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly section of this manual_
FRONT WHEEL TOE-IN/CAMBER
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 25)
CAUTION:
and smoking materials away from bat-
teries. Always wear eye protection when around batteries.
The front wheel
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 24)
o Block up axle securely+,
If your battery is too weak to start the engine, it should be
recharged,, If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR 1S EQUIPPED WITH A 12
VOLT NEGATtVE GROUNDED SYSTEM THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM, DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES,
°Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose),,
°Repair tire and reassemble,,
=On rear wheels only: align grooves in rear wheel hub and axle. Insert square key,,
•Replace washers and snap retaining ring securely in axle groove,,
°Replace axle cover,,
WASHERS
RETAINING
RING
TO
•Connect each end of the RED cable to the POSITIVE
(+)terminal of each battery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGA- TIVE
°Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
°BLACK cable first from chassis and then from the fully charged battery_
=RED cable last from both batteries.
POSITIVE TERMINAL | NEGATIVE TERMINAL |
Q I
AXLE COVER
_SQUARE KEY
(REAR WHEEL ONLY)
FIG. 24 | CHASSIS |
CABLES
CHARGED
BATTERY
POSITIVE TERMINAL | NEGATIVE TERMINAL |
FIG+ 25
23
