ASSEMBLY
CONNECT BATTERY (See Figs. 2 and 3)
CAUTION: Do not short battery termi- nals. Before cormecting battery, re- move metal bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to prevent sparking from acciden- tal grounding.
oRemove cardboard packing from seat pan and lift seat pan to raised position.
o Open battery box door.
o Remove termina! protective caps and discard.
°If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for'minimum of one hour at
•First connect RED battery cable to positive (+) terminal with hex bolt, flat washer, lock washer and hex nut as shown., Tighten securely..
°Connect BLACK grounding cable to negative
. Close battery box door:.
Open battery box door for:
. Inspection for secure connections (to tighten hard- ware),,
=Inspection for corrosiorL ° Testing battery°
° Jumping (if required). o Periodic charging
DISCARD
TERMINAL
POSITIVEPROTECTIVE
(RED) CABLE CAPS
LOCK
HEX WASHER
NUT
FLAT
WASHER
HEX
BOLT
/
NEGATIVE
(BLACK) CABLE
FIG. 2
SEAT
PAN
BOX DOOR
FIG. 3
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment bolt.
°Remove cardboard packing on seat pan,
o Place seat on pan and assemble shoulder bolt.
°Assemble adjustment bolt, lockwasherandflatwasher loosely., Do not tighten.
°Tighten shoulder'bolt securely°
°Lower'seat into operating position and sit on seat.
°Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down (See Fig.. 8)_
oGet off seat without moving its adjusted position. o Raise seat and tighten adjustment bolt securely.
SEAT
SEAT PAN
SHOULDER
BOLT X
| FLAT WASHER |
ADJUSTMENT | LOCK WASHER |
BOLT |
|
FIG. 4
8
