BELT INSTALLATION -
•Install new belt in reverse order of removal,
•Make sure belt is in all pulley grooves and inside all belt guides.
•Instatl mower in reverse order of removal instructions,
Mandrel | Idler Pulleys |
Pulley |
|
Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle.
If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted.
•Depress clutch/brake pedal and engage parking brake.
•Measure distance between brake operating arm and nut "A" on brake rod.
•If distance is other than
•Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is necessary. Contact your nearest authorized service centerldepartment.
With Parking Brake
"Engaged"
Nut "A"
/am Nut
_Operating Arm
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.
•Remove mower (See "TO REMOVE
MOWER" in this section of this manual.)
•Remove belt from stationary idler and clutching idler.
•Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keepers.
•Pull belt toward front of tractor and
remove downwards from around engine pulley.
•Install new belt by reversing above procedure.
Engine
Pulley
Clutching
Idler
Stationary /
Idler
Transaxle
.,._...D
Pulley ___
TRANSAXLE GEAR SHIFT LEVER ADJUSTMENT
The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:
•Make sure transaxle is in neutral (N). NOTE: When the tractor rear wheels
move freely, the transaxle is in neutral.
•Loosen adjustment bolt in front of the right rear wheel.
•Position the gear shift lever in the neutral (N) position.
•Tighten adjustment bolt securely. NOTE: If additional clearance is needed
to get to adjustment bolt, move mower deck height to the lowest position.
23
