TOREMOVEWHEELFORREPAIRS
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).
•Repair tire and reassemble.
•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.
•Replace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant
may be purchased from your local parts dealer. 13re sealant also prevents tire dry rot and corrosion.
WashersA
RetainingRing _ ff/'__
Square Key _' "_'_"
(Rear Wheel Only)
TO START ENGINE THAT HAS A WEAK BATTERY
_CAUTION:
ies. Always wear eye protection when around batteries.
If your battery is too weak to start the engine, it should be recharged. If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: Your tractor is equipped
with a 12 volt negativ e grounded system. The other vehicle must also be a 12 volt
negative grounded system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
•Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-
tery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cabk_to goed CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER -
•Remove BLACK cable first from chassis
and then from the fully charged battery. - Remove RED cable last from both bat-
tedes.
Positive Terminal | NegativeTerminal |
Charged
Ballet
PositiveNegative
TerminalTerminal
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the gdll.
•Close hood.
TO REMOVE HOOD AND GRILL AS- SEMBLY
•Raise hood.
•Unsnap headlight wire connector.
•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
•To replace, reverse above procedures.
Headlight Wire
\Connector
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poody, stop running, or pre- vent it from starting.
•Check wiring. See electrical widng dia- gram in the Repair Parts section of this manual.
25
