Craftsman 919.762500 manual Review the use of the adjustable roxz e, Tsiasg Soaps/Chemicals

Whenenginestarts,graduallymovechokeleverto

RUNposition.

}fenginedoesnotstartafter5pu_ls,piacechoke backtorunposition.

For hot engine starts make sure choke/run }ever is in the run position, Make sure fue_ shut off valve is open and throttie is in the Rabitt position.

NOTE: If any leaks are present shut unit down and tighten fittings.

How To Use Yeur Pressure Washer

On the end of your spray gun is a nozzle that you can twist from side to side, With the adjustable nozzle you can adjust the nozzie to either high pressure or Iow pressure.

Turn the nozzle in a counter clockwise direction to achieve low pressure. Turn nozzie clockwise for high pressure.

For most effective cleaning, keep spray nozzie between 8 and 24 inches of cleaning sudaceo

iMPORTANT: If you get spray nozzle too close, especially on high pressure, you may damage the cleaning su.dace.

The pressure control knob is located on the pump. You can increase the pressure by turning the knob

ciockw_se or decrease the pressure by turning the knob counterclockwise.

/ rIq _,', ", /

_08	::'/_ _-._,........., .'\.',-,
	,. \ i : .j ...,, x%	, ,

NOTE; The maximum pressure for the unit is set at its maximum setting at the factory. Do not attempt Io adjust the pressure higher than this factory setting.

Prepare the soapichemica_ as required by your job.

Insert soapichemicai line into your container (soap/ chemicals not inc!uded).

NOT_; The first step involves applying an appropriate soap/chemical solution to penetrate and loosen grime.

The soap/chemica! is appIied at iow pressure to avoid

splashing, over spray and waste. Leave the solution on surface for 3 to 5 minutes to atiow solution to work.

NOTE: The second step involves cleaning the surface you have prepared with the pressure washer and then rinsing it clean.

Turn the adjustable nozzie counter c;ockwise to low

pressure mode. Soap/chemicais cannot be applied with nozzle in high pressure position.

o Review the use of the adjustable r;oxz e.

o Connect garden hose to water infer (see "To Start "_,<our Pressure Washer"), check that high p_{:-ss_.._rehose is connected to spray gun and pump (s.i _ Assembly},

and start engine.

o AppIy soap/chemicals to dry surfac .'.string from the bottom and working up.

o Al!ow the soap/chemicals to soak i_ b : :,,een 3-5 minutes before washing and rinsing?;.

For cleaning, start at iower portion (::i }:_ to be

washed and work upward_ using !o;: ::.en over.- iapping strokes.

Your pressure washer is equipped with a (;isemicaI injector adjustment knob. With the k_u._b_uily opened you will get maximum chemical draw. With knob fui_y

ciosedyouwiilgetnocbernicaidraw.r knob_n counter clockwise direction to achieve _(re chemica_ draw and clockwise for less chemicai d_"_w.

///

;/i/

t_siasg Soaps/Chemicals

IMPORTANT; Use soaps and chemicals that are designed specifically for use with pressure washers. To apply soap/ chemicals follow these steps:

After using the p_essure washer, it is recommended the pump, chemical iniector and chemical !ire be flushed with clear wate._: To do so. simply place chemical injector hose in water arsd siphon for I to 2 minutes.

11