Tools Required for Assembly
Adjustable wrench
1/2" Socket
Remove Pressure Washer from Carton
,Open box from the top. Locate and remove from box, the parts box, which includes gun, handle, wand,oil, knobs and J bolts. Next remove the parts bag and the handle.
•Cut carton along dotted lines.
•Remove all carton inserts.
,,Roil unit through opening in carton.
Note: The pressure hose and chemical hose are located at the bottom of the box.
Preparing the Pressure Washer for First Use
Note: Included with your pressure washer is a video tape on how to prepare your unit for operation. It is recommended you view this tape before performing the next steps.
1.• insert handle onto frame.
•Slide J bolts into frame.
•Tighten knobs turning in c!ockwise direction.
_ten knob in clockwise direction to threaded end of d bo_,)
(insert J boff here. Threaded end goes in bottom hole)
2.• Remove wood plank from the frame of the unit.
An adjustable wrench is required. Discard bolt and board.
3.• Mount the rubber isolator to the frame. To
mount isolator place threaded end of bolt through the washer. Next with washer on bolt
place threaded end of bolt through larger hole in bottom of the rubber isolator. Place threaded
portion of isolator through the front hole
location where the wood plank was mounted on the pressure washer. Next place Iockwasher over threaded portion of bolt that has been ptaced through the mounting hole in the pres- sure washer and use nut to tighten isolator to the frame. Tighten nut with an adjustable wrench. All isolator parts are supplied in parts bag.
NUT
,.._!! _ LOCKWASHER
PRESSU_i _/ o
WASHER ,; _;_"f /;'
BOLT
,• Connect wand with nozz{e assembly to gun. To tighten, turn knob in clockwise direction. Hand tighten.
