BEFORE STARTING
Read and understand all Important Safety Instructions in the front of this manual and the following Cautions and Warnings before starting the pressure washer.
Filler cap/dipstick
•Never fill fuel tank completely. Fill tank to 1/2" below bottom of filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine.
•Never fill fuel tank indoors. Never fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.
•Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust con- tains carbon monoxide, an odorless and deadly gas.
•Never turn water supply off while pressure washer engine is running or damage to pump will result.
•DO NOT use hot water, use cold water only.
•DO NOT stop spraying water for more than two minutes at a time.
1.Add fresh high quality unleaded gasoline with a pump octane rat- ing of 86 or higher. Do not over- fill. Wipe up spilled fuel before starting the engine.
2.Remove filler cap/dipstick and add engine oil (supplied) to engine. NOTE: There will be a slight amount of oil in the engine from factory testing. Always check oil level before each start- up.
3.Verify the filter screen is in water inlet of pump, as shown.
Filter Screen
4.Connect high pressure hose to pump outlet.
5.Connect water source to pump inlet.
NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i.
|
| High |
Water |
| Pressure |
Source |
| Hose |
|
|
|
6.If you are applying a chemical or cleaning solution, See How To
Siphon Chemicals/Cleaning Solvents in Operation section of this manual.
7.Turn water source on.
NOTE: Make sure water supply is turned on.
13- ENG | D25083 |
