TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See side of tire for proper PSI). If tires are over or underinflated, you will not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
. Raise mower to its highest position.
. At the midpoint of both sides of mower, measure height from bottom edge of
mower to ground.. Distance %" on both sides of mower should be the same or
within 1t4" of each other,.
•If adjustment is necessary, make adjust- ment on one side of mower only.
. To raise one side of mower, tighten lift link adjustment nut on that side..
• To lower one side of mower, loosen lift link adjustment nut on that side_
NOTE: Each fullturnofadjustmentnutwill change mower height about !18".
. Recheck measurements after adjusting.
FRONT-TO-BACK ADJUSTMENT
•To raise front of mower, loosen nut"F" from trunnion on both front links, Tighten nut
"E" on both front links an equal number of turns.. The two front links must remain
equal in length.
. When distance "D" is 118" to 1/2" lower
at front than rear, tighten nut "F" against trunnion on both front links.
,Recheck
°_\', | l | oo! |
_"{_ | \ __- | Mandrel |
Both Fronl nks Should be ual in Length
)
/
Bottom edge |
| Bottom edge of |
of mower to ___. | _ | @Qw,er to ground |
0 o,n0 |
| |
AT L2L | ||
| _L_ | Suspension Arm |
...... | o__ | / |
A |
| |
Lift Link |
|
|
Adjustment Nut |
|
IMPORTANT: Deck must be level
links equally so mower will stay level side-
To obtain the best cutting results, the mower housing should be adjusted so thatthe front is approximately t18" to 112" lower than the rear when the mower is in its highest position,. Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.
• Before making any necessary adjust- ments, check that both front links are equal in length.
•If links are not equal in length, adjust one link to same length as other linko
•To lower front of mower loosen nut "E"
on both front links an equal number of turns_
•When distance "D" is II8" to 1/2" lower
at front than rear, tighten nuts "F" against |
|
trunnion on both front links. | 22 |
Nut "E"
Fron kinks ...... "