![](/images/new-backgrounds/1250361/25036147x1.webp)
2.9 Installing SODIMMs
Notes | The modules can only fit into a socket one way. |
| The gold pins must point down into the |
| SODIMM socket. |
The procedure for installing SODIMMs appears below. Please follow these steps carefully.
1.Make sure that all power supplies to the system are switched off
2.Install the SODIMM card. Install the SODIMM so that its gold pins point down into the SODIMM socket.
3.Slip the SODIMM into the socket at a 45 degree angle and care- fully fit the bottom of the card against the connectors.
4.Gently push the SODIMM into a perpendicular position until the clips on the ends of the SODIMM sockets snap into place.
5.Check to ensure that the SODIMM is correctly seated and all con- nector contacts touch. The SODIMM should not move around in its socket.
2.10ATX power Connector (CN5)
The
Important Make sure that the ATX power supply can take at least a 10 mA load on the 5 V standby lead (5 VSB). If not, you may have difficulty power- ing on your system.
14 |