LQ™ 10P USER MANUAL
Special note for permanent installation
When installing the Crest LQ 10P,AC power runs should be used and a certified electrician consulted to be sure that all AC wiring complies with local codes and regulations. Properly affix a cable clip to the cabinet to relieve strain on the IEC power cord connected to the amplifier module at
(2) so the power cord cannot vibrate loose.
USE OF LQ 10P WITH A SUBWOOFER
The
The pole is
GETTING A SIGNAL TO THE LQ 10P
There’s a variety of ways to input a signal to the LQ 10P system. Micro- phone input use is covered in a specific section below.The balanced line level inputs allow the use of a 1/4" phone plug, either a standard single- ended
While the standard,
LEVEL CONTROL ADJUSTMENT
The LQ 10P is equipped with a Volume control to facilitate use in many different applications.With the Volume control adjusted fully clockwise, gain is at maximum and the input sensitivity is 0.5 Volts RMS for
If the mixer board indicates output signal clipping, then the LQ 10P’s full power capability is not being utilized cleanly. Clipping the signal before it gets to the LQ 10P is not optimal. In this case, reduce the mixer output level and turn up the Volume control on the LQ 10P.
The amplifiers in the LQ 10P are equipped with clipping prevention compression, with an LED indicator to show if compression has engaged. If the sound seems heavily compressed, check this indicator; if the LED is
9