2Setup
2.3.5Bridge-Mono Mode
Overview: Turn on the amp, enable
1.Be sure that no cables are connected to the amplifi er. Turn on the
2. Under the LCD Control Screen, press the Menu/Exit button. Press the Next button until you see OUTPUT MODE on the screen. If N/A is displayed, OUTPUT MODE is locked via software. If LOCKOUT is displayed, all the LCD screens are locked via software.
3.Press an Encoder knob to select BRIDGE MONO. Press the knob again to confi rm your choice. Press Menu/Exit. Turn down both level controls (Encoders) until you reach maximum attenuation.
4.IMPORTANT: Turn off the amplifier and unplug its power cord.
INPUTS: There are three ways to connect an input signal to the amplifi er (Figure 2.13):
•Connect an analog signal source to the
•Connect an AES/EBU digital signal source to the Digital Input IN connector.
NOTE: Crown provides a reference of wiring pin assignments for commonly used connector types in the Crown Amplifier Application Guide available at www.crownaudio.com.
OUTPUTS: Use Class 2 output wiring. There are two ways to wire the amplifi er output connectors for
1)Wire the speaker across the red binding post of each channel (Figure 2.14). Do not use the black binding posts when operating in
2)Wire the speaker only to the top Speakon® connector as shown in Table 3 and Figure 2.14.
Figure 2.12
The LCD Control Screen
Figure 2.13
|
|
|
|
|
|
| NOTE: In |
|
|
|
|
|
|
| mode, the Channel 1 |
|
|
|
|
|
|
| Level control sets the |
Menu/Exit | Prev | Next | level; the Channel 2 Level | ||||
|
|
|
|
|
|
| control is defeated. All |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| controls are hidden and |
|
|
|
|
|
|
| disabled. |
Table 3
Top Speakon® Wiring for
PIN | 1+ | 2+ |
|
|
|
SPKR | + | – |
|
|
|
Figure 2.14
Wiring a Speaker in
page 10 | Operation Manual |
