3 Operation
3.5Back Panel Controls, Indicators and Connectors
A. Fans
Provide
ANALOG INPUTS SECTION
B. Balanced Analog XLR Inputs
A
C. Balanced Analog XLR Loop-Through Outputs
Two
OUTPUTS SECTION
D. 4-Pole Speakon® Output Connectors
Two
These two connectors accept
2.10and Tables 1, 2 and 3 for connector wiring. The top Speakon® connector is wired for both channels so it can be used for
wiring or for stereo wiring of two speakers to a single Speakon® connector.
E. Binding Post Output Jacks
One pair per channel of
F. Power Cord Connector
Standard 20 amp IEC inlet. Voltage range is indicated above IEC inlet.
G. Reset Switch/Circuit Breaker
If the current draw of the amplifi er exceeds safe limits, this breaker automatically disconnects the power supply from the AC mains. The switch resets the circuit breaker.
H. MAC Address
This specifi c amplifi er’s network identifi er that is burned into its fi rmware.
I. Preset Indicator
LED fl ashes to signal the number of the current preset if active. LED is green if the preset values have not been changed once loaded. LED is yellow if the preset values have been changed since they were loaded.
J. Reset Button
To restore factory default settings: Press the Reset Button with a thin,
K. Data Indicator
Flashes yellow only when the amplifi er is polled for data, or is polled to see whether it is online.
DIGITAL INPUTS SECTION
L. AES/EBU Digital Input
This
M AES/EBU Digital Loop-through Output
Male XLR
It is not recommended to loop through more than four amplifi ers. If larger distribution of AES is needed, the use of an AES distribution amplifi er is recommended.
NETWORKING SECTION
N. Link/Act Indicator
Shows network activity.The LINK ACT LED illuminates when the network port is connected and fl ashes when network activity is detected.
O. Network Connector
This EtherCon® Ethernet connector is for networking. Warning: Only connect to networks that remain inside the building.
P. Cond Indicator
Turns on if the amplifi er is set to be the CobraNet conductor. The CobraNet conductor is a CobraNet node that provides the master timing clock for the CobraNet digital audio transport network.
Figure 3.2 Back Panel Controls and Connectors
Operation Manual | page 13 |