Front Wheel Drive Lever
The front wheel drive lever is located in the floorboard, below and to the left of the seat.
Use the front wheel mechanism only when additional traction is needed to drive the tractor. For example: when operating ground engaging equipment such as a front end loader; when climbing slopes; or when operating in wet, sandy or loose soil conditions.
•To engage the front wheel drive mechanism, depress the clutch pedal and push the front wheel drive lever downward. See Figure 15.
•To disengage the front wheel drive, depress the clutch pedal and pull the lever upward.
FRONT WHEEL
DRIVE LEVER
Disengaged
Engaged
Figure 15
Differential Lock Pedal
Located at the rear of the right floor board, the differ- ential lock is used to gain additional traction when operating the tractor on wet or loose soil. When the pedal is depressed the rear wheels of the tractor are prevented from rotating independently of one another. See Figure 16.
DIFFERENTIAL
LOCK PEDAL
Engage
Figure 16
WARNING: When operating with the differential lock engaged, the tractor will be difficult to steer. To prevent loss of control of the tractor, do not drive the tractor on roadways or at speeds above 5 MPH with the differential lock engaged.
•To engage the differential lock, lightly step on the differential lock pedal with your heel.
•To disengage, simple release the pedal.
Hydraulic Control Levers
The hydraulic control levers, consisting of the position control and draft control levers, are located on the right fender. See Figure 17.
Lower 
Raise
Lower 
Raise
|
| POSITION |
|
|
| DRAFT |
|
| CONTROL |
|
|
| CONTROL |
|
|
|
|
| ||
|
| LEVER |
|
|
| LEVER |
Figure 17
Use these control levers to control the working depth and pull of implements attached to the three point hitch as follows:
•Using Position Control — This will control the working depth of
•Using Draft Control — This will control the pull of the
18
