Cub Cadet LT1042 manual Gas and Oil Fill-up, Shipping Brace Removal, Tractor Set-Up

SECTION 3: TRACTOR SET-UP

Gas and Oil Fill-up

The gasoline tank is located under the fender and has a capacity of three and-a-half gallons. Unthread the fuel cap by turning it counterclockwise. Use only clean, fresh (under 30 days old), unleaded gasoline. Fill tank to no more than four inches below the top of the filler neck to allow space for fuel expansion. Do not overfill.

WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes, and other sources of ignition.

IMPORTANT: Your tractor is shipped with oil in the engine. However, you MUST check the oil level before operating. Refer to Checking the Oil Level on page 19 for detailed instructions. Be careful not to overfill.

Shipping Brace Removal

WARNING: Make sure the riding mower’s engine is off, set the parking brake and remove the ignition key before removing the shipping brace.

•Locate the shipping brace, if present, and warning tag found on the right side of the cutting deck.

•While holding the discharge chute with your left hand, remove the shipping brace with your right hand by grasping it between your thumb and index finger and rotating it clockwise.

WARNING: The shipping brace, used for packaging purposes only, must be removed and discarded before operating your riding mower.

WARNING: The mowing deck is capable of throwing objects. Failure to operate the riding mower without the discharge cover in the proper operating position could result in serious personal injury and/or property damage.

8