Nortel Networks 40M2420 manual Routing Information Protocol Interface Configuration

Alteon OS Command Reference

/cfg/l3/rip/if <interface number>

Routing Information Protocol Interface Configuration

[RIP Interface 1 Menu]

version	- Set RIP version
supply	- Enable/disable supplying route updates
listen	- Enable/disable listening to route updates
poison	- Enable/disable poisoned reverse
split	- Enable/disable split horizon
trigg	- Enable/disable triggered updates
mcast	- Enable/disable multicast updates
default	- Set default route action
metric	- Set metric
auth	- Set authentication type
key	- Set authentication key
enable	- Enable interface
disable	- Disable interface
current	- Display current RIP interface configuration

The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by default.

NOTE – Do not configure RIP1 parameters if your routing equipment uses RIP version 2.

Table 6-71RIP Interface Menu Options (/cfg/l3/rip/if)

Command Syntax and Usage

version 12both

Configures the RIP version used by this interface. The default value is version 2.

supply disableenable

When enabled, the switch supplies routes to other routers. The default setting is enabled.

listen disableenable

When enabled, the switch learns routes from other routers. The default setting is enabled.

poison disableenable

When enabled, the switch uses split horizon with poisoned reverse. When disabled, the switch uses only split horizon. The default setting is disabled.

split disableenable

Enables or disables split horizon. The default setting is enabled.

40M2420, April 2007 Chapter 6: The Configuration Menu „ 267