Nortel Networks 40M2420 Default Gateways, If configuring VLANs, specify a Vlan for the interface

Alteon OS Command Reference

4.If configuring VLANs, specify a VLAN for the interface.

This prompt appears if you selected to configure VLANs back in Part 1:

Current VLAN: 1

Enter new VLAN [1-4090]:

Enter the number for the VLAN to which the interface belongs, or press <Enter> without spec- ifying a VLAN number to accept the current setting.

5.At the prompt, enter y to enable the IP interface, or n to leave it disabled:

Enable IP interface? [y/n]

6.The system prompts you to configure another interface:

Enter interface number: (1-128)

Repeat the steps in this section until all IP interfaces have been configured. When all interfaces have been configured, press <Enter> without specifying any interface number.

Default Gateways

1.At the prompt, select a default gateway for configuration, or skip default gateway config- uration:

IP default gateways:

Enter default gateway number: (1-132)

Enter the number for the default gateway to be configured. To skip default gateway configura- tion, press <Enter> without typing a gateway number and go to “IP Routing” on page 41.

2.At the prompt, enter the IP address for the selected default gateway:

Current IP address: 0.0.0.0

Enter new IP address:

Enter the IP address in dotted decimal notation, or press <Enter> without specifying an address to accept the current setting.

3.At the prompt, enter y to enable the default gateway, or n to leave it disabled:

Enable default gateway? [y/n]

40 „ Chapter 2: First-Time Configuration 40M2420, April 2007