Nortel Networks 40M2420 manual Optional Setup for Telnet Support, # /cfg/sys/access/tnet

Alteon OS Command Reference

4.At the prompt, decide whether to make the changes permanent:

Save changes to flash? [y/n]

Enter y to save the changes to flash. Enter n to continue without saving the changes. Changes are normally saved at this point.

5.If you do not apply or save the changes, the system prompts whether to abort them:

Abort all changes? [y/n]

Enter y to discard the changes. Enter n to return to the “Apply the changes?” prompt.

NOTE – After initial configuration is complete, it is recommended that you change the default passwords as shown in “Setting Passwords” on page 43.

Optional Setup for Telnet Support

NOTE – This step is optional. Perform this procedure only if you are planning on connecting to the GbE Switch Module through a remote Telnet connection.

1.Telnet is enabled by default. To change the setting, use the following command:

>># /cfg/sys/access/tnet

2.Apply and save SNMP and /or telnet configuration(s).

>>System# apply

>>System# save

42 „ Chapter 2: First-Time Configuration 40M2420, April 2007