Nortel Networks 40M2420 manual Setup Part 3 VLANs, Enter the new Vlan name at the prompt

Alteon OS Command Reference

Setup Part 3: VLANs

If you chose to skip VLANs configuration back in Part 1, skip to “Setup Part 4: IP Configura- tion” on page 39.

1.Select the VLAN to configure, or skip VLAN configuration at the prompt:

VLAN Config:

Enter VLAN number from 2 to 4094, NULL at end:

If you wish to change settings for individual VLANs, enter the number of the VLAN you wish to configure. To skip VLAN configuration, press <Enter> without typing a VLAN number and go to “Setup Part 4: IP Configuration” on page 39.

2.Enter the new VLAN name at the prompt:

Current VLAN name: VLAN 2

Enter new VLAN name:

Entering a new VLAN name is optional. To use the pending new VLAN name, press <Enter>.

3.Enter the VLAN port numbers:

Define Ports in VLAN:

Current VLAN 2: empty

Enter ports one per line, NULL at end:

Enter each port, by port number or port alias, and confirm placement of the port into this VLAN. When you are finished adding ports to this VLAN, press <Enter> without specifying any port.

4.Configure Spanning Tree Group membership for the VLAN:

Spanning Tree Group membership:

Current Spanning Tree Group index: 1

Enter new Spanning Tree Group index [1-127]:

5.The system prompts you to configure the next VLAN:

VLAN Config:

Enter VLAN number from 2 to 4094, NULL at end:

Repeat the steps in this section until all VLANs have been configured. When all VLANs have been configured, press <Enter> without specifying any VLAN.

38 „ Chapter 2: First-Time Configuration 40M2420, April 2007