Speed Control Pedals
Forward Reverse
The speed control pedals are located Pedal Pedal on the right side of the traction unit.
The speed control pedals must be in the neutral position to start the tractor engine.
Pushing the forward pedal causes the mower to move forward. Pushing the reverse pedal causes the mower to move backward. Consequently, these pedals control all of the movements of the tractor. Driving and steering utilizing these control
pedals is quite different from conventional tractors, and will take some practice to master. Refer to the Operation section for instructions on using the speed control pedals.
completed according to the instructions in this manual and the engine manual.
Throttle Control
The throttle control is located on the RH console to the right of the operator’s seat. When set in a given position, a uniform engine speed will be maintained. The trottle control moves
between the fast
and slow
positions.
Push the throttle control handle forward to increase the engine speed. The tractor is designed to operate with the throttle
control in the fast position
(full throttle) when the tractor is
Ignition Switch
The ignition switch is located on the RH console to the right of the operator’s seat. The ignition switch has three positions as follows:
OFF — The engine and electrical system is turned off.
RUN — The tractor electrical system is energized.
OFF
RUN
START
being driven and the mower deck is engaged.
Pull the throttle control handle rearward to decrease the engine speed.
Parking Brake
The parking brake is located on the left side |
of the tractor and to the left side of the brake |
pedal. Push the parking brake and brake pedal |
down at the same time until it latches to engage |
START — The starter motor will turn over the engine. Release the key immediately when the engine starts
NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use.
PTO (Power
The PTO switch is located on the RH console to the right of the operator’s seat next to the ignition switch.
The PTO switch operates the electric PTO clutch mounted on the bottom of the engine crankshaft. Pull the switch knob upward to engage the PTO clutch, or push the knob downward to disengage the clutch.
The PTO switch must be in the “disengaged” position when starting the engine.
Digital Tachometer and Hour Meter
The tachometer/hour meter panel is located on the RH console to the right of the operator’s seat. The hour meter records the hours that the tractor has been operated in the digital display. The tachometer provides engine speed (RPM), and service reminders (oil, lube) in the digital display.
The tachometer/hour meter is activated whenever the ignition switch is turned to the “ON” position. Keep a record of the actual hours of operation to assure all maintenance procedures are
the parking brake. Push the pedal downward |
|
and release to disengage the parking brake. | BRAKE |
NOTE: If the speed control pedals are not in the | |
neutral position when engaging the parking |
|
| |
brake, the engine will stop. The parking brake |
|
must be placed in the engaged position when starting the tractor engine.
Fuel Tank Cap
The fuel tank caps are located on top of the fuel tanks. Turn the cap and pull upward to remove.
Push the cap downward on the fuel tank fill neck and turn clockwise to tighten. Always
Transmission Bypass Valves (Not Shown)
The transmission bypass valves (one for each the RH and LH transmission) are located just in front of the engine and just behind the seat.
When engaged, the two valves open a bypass within the hydrostatic transmissions, which allows the tractor to be pushed short distances by hand. Refer to the Maintenance & Adjustments section for instructions on using the bypass feature.
Caution: Never tow your tractor. Towing the tractor with the rear wheels on the ground may cause severe damage to the transmissions.
Section 4 — Controls and Features |
| 15 |
| ||
|
|
|