IMPORTANT SAFETY INSTRUCTIONS

TROUBLESHOOTING

12.NONUSE PERIODS - The power cord of the product should be unplugged from the outlet when left unused for long periods of time.

13.OUTDOOR ANTENNA GROUNDING - If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges.

Below diagram provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the g rounding electrode. See Figure 1.

EXAMPLE OF ANTENNA GROUNDING

ANTENNA

LEAD WIRE

GROUND

CLAMP

ANTENNA DISCHARGE UNT

19.DAMAGES REQUIRING SERVICE - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions.

a) When the power-supply cord or plug is damaged. b) If liquid has been spilled, or objects have fallen

into the product.

c) If the product has been exposed to rain or water. d) If the product does not operate normally by

following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improving adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e) When the product exhibits a distinct change in performance - this indicates a need for service.

20.REPLACEMENT PARTS - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part, Unauthorized substitutions may result in fire, electric shock or other hazards.

Check the chart below for a possible cause of the problem you are experiencing before requesting service for this unit, Some simple checks or minor adjustment on your part may eliminate the problem and restore proper operation. Let the technician maintain the unit. Keep away from static electricity properly before maintenance as loader, key IC are easy to be damaged by it.

Trouble

Suggested solution

 

 

No power

Plug the power cord into the power outlet tight to turn on/off once

 

 

 

Disc access time within 10-20 seconds is normal

Cannot read disc

The disc is scratched or defiled (change disc)

 

The code of disc is different from the code of unit (change the disc)

 

PAL to NTSC error (Set video output as AUTO)

 

 

No picture

If your TV does not have P-Scan function, pressing VIDEO button on the

remote may cause this. Press VIDEO button again to rectify.

 

 

 

 

Ensure that the equipment is connected properly.

No sound

Ensure that the TV or audio equipments are not muted.

Ensure that the audio output setting is correct.

 

 

 

Picture is distorted

The picture will be somewhat distorted at times.

during fast forward or

ELECTRIC

GROUNDING CONDUCTORS

SERVICE

 

SQUIPMENT

 

 

GROUD CLAMP

 

POWER SERVICE GROUNDING

 

ELECTRODE SYSTEM

14.LIGHTNING - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.

15.POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or other electric light or power circuits. When installing an outside antenna system, extreme care should be taken to keep from touching power lines or circuits as contact with them might be fatal.

16.OVERLOADING - Do not overload wall outlets, extension cords, or integral convenience receptacles a s this can result in a risk of fire or electric shock.

17.OBJECT AND LIQUID ENTRY - Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

18.SERVICING - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

21.SAFETY CHECK - Upon completion of any service or repair to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

22.HEAT - The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat.

23.Keep minimum distances (5cm) around the apparatus for sufficient ventilation.

24.The ventilation should not be impeded by covering the rear panel for ventilation with items, such as newspapers, table-cloths, curtains, etc.

25.No naked flame sources, such as lighted candles, should be placed on the apparatus.

26.Don’t use the apparatus in tropical climates.

27.Where the mains plug is used as the disconnect device, the disconnect device shall remain readily operable.

28.The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.

29.Attention should be drawn to the environmental aspects of battery disposal. Don’t throw used batteries in dustbin. Please contact your retailer in order to protect the environment.

reverse

This is normal advance or reverse.

 

 

 

No (4:3)(16:9) picture

Choose the correct setup at TV TYPE item that matches the TV set.

 

 

Remote control does

Check the batteries being installed with correct polarities.

Replace the batteries depleted. Point at remote control sensor and

not function

operate it within 5 meters.

 

 

 

Unit,s or remote

 

control buttons are

 

not functioning or

Turn the unit off and then back to on. Alternatively, turn off the unit,

other abnormal

disconnect the AC power cord for 5 to 10 minutes and then reconnect it.

phenomena

 

 

 

 

If the audio soundtrack and/or subtitle language does not exist in the

Audio soundtrack and/

disc, the language selected at the initial settings will not be seen/heard.

or subtitle language

Alternative audio soundtrack (or An alternative language is not selected

not found in settings

with discs which contain subtitle) language cannot be more than one

 

language selected.

 

 

 

This function depends on software availability.

Can not change angle

Even if a disc has a number of angles recorded,

 

these angles may be recorded for specific scenes only.

 

 

No playback menu

This function is suitable for VCD with playback control disc.

 

 

Miscellaneous

In program playing mode, no repeat, A-B functions are available.

 

Helpline No . UK/Northern lr ela nd 0800 032 5264 Rep. lr ela nd 1800 315 697

 

Helpline No . UK/Northern lr ela nd 0800 032 5264

Rep. lr ela nd 1800 315 697

W eb S upport www.curtisint.com

 

W eb S upport www.curtisint.com

 

Model Number: DVD3602UKT

2

Model Number: DVD3602UKT

19

 

 

 

 

Page 3
Image 3
Curtis DVD3602UKT warranty Troubleshooting, Into the product, Trouble Suggested solution