INSTALLATION

Connecting VHF and UHF

Antennas, continued

If you use a 300-ohm antenna

3 Plug the combiner into the

with twin flat leads, follow the

terminal on the rear panel of

directions below, but skip step 1.

the TV/VCR.

1Push the stem of the rod antenna into the antenna

mount.

2Connect both antenna leads to the combiner.

Connecting Cable TV Systems to the TV/VCR

Choose one of the sections below for connecting a cable system.

This TV/VCR is cable-ready; you don’t need a converter for basic cable channels.

Cable Without a

Converter Box

To connect cable without a converter box:

1Plug the incoming cable into the terminal on the rear panel of the TV/VCR.

Cable With a

Converter Box

If your cable company scrambles some channels and requires you to use a converter box for only those channels, use these instructions.

You will need the following pieces of equipment, which you can purchase from an electronics store:

A two-way splitter

An RF (A/B) switch

Four lengths of coaxial cable

1Plug the incoming cable into the 2-way splitter.

CHAPTER TWO: INSTALLATION

7

Page 13
Image 13
Curtis Mathes CMC13003 owner manual Installation, Connecting VHF and UHF Antennas, Cable Without a Converter Box