Cypress CY62146E MoBL manual Features, Functional Description, Logic Block Diagram

Features

■Very high speed: 45 ns

■Wide voltage range: 4.5V–5.5V

■Ultra low standby power

❐Typical standby current: 1 μA

❐Maximum standby current: 7 μA

■Ultra low active power

❐Typical active current: 2 mA at f = 1 MHz

■Easy memory expansion with CE and OE features

■Automatic power down when deselected

■CMOS for optimum speed and power

■Available in Pb-free 44-pin TSOP II package

CY62146E MoBL→

4-Mbit (256K x 16) Static RAM

mode reduces power consumption by more than 99% when deselected (CE HIGH). The input and output pins (IO0 through IO15) are placed in a high impedance state when:

■Deselected (CE HIGH)

■Outputs are disabled (OE HIGH)

■Both Byte High Enable and Byte Low Enable are disabled (BHE, BLE HIGH)

■Write operation is active (CE LOW and WE LOW)

To write to the device, take Chip Enable (CE) and Write Enable (WE) inputs LOW. If Byte Low Enable (BLE) is LOW, then data from IO pins (IO0 through IO7) is written into the location specified on the address pins (A0 through A17). If Byte High Enable (BHE) is LOW, then data from IO pins (IO8 through IO15) is written into the location specified on the address pins (A0 through A17).

Functional Description

The CY62146E is a high performance CMOS static RAM organized as 256K words by 16 bits. This device features advanced circuit design to provide ultra low active current. It is ideal for providing More Battery Life™ (MoBL→) in portable appli- cations such as cellular telephones. The device also has an automatic power down feature that reduces power consumption when addresses are not toggling. Placing the device into standby

To read from the device, take Chip Enable (CE) and Output Enable (OE) LOW while forcing the Write Enable (WE) HIGH. If Byte Low Enable (BLE) is LOW, then data from the memory location specified by the address pins appears on IO0 to IO7. If Byte High Enable (BHE) is LOW, then data from memory appears on IO8 to IO15. See Table 1 for a complete description of read and write modes.

For best practice recommendations, refer to the Cypress application note AN1064, SRAM System Guidelines.

Logic Block Diagram

DATA IN DRIVERS

A10
A9	DECODER
A8
A7
A6
A5
A4	ROW
A3
A2
A1
A0

256K x 16 RAM Array

SENSE AMPS

IO0–IO7

IO8–IO15

	COLUMN DECODER
								BHE
								WE
11		12	13	14	15	16	17	CE
A		A A		A	A	A	A	OE
								BLE

Cypress Semiconductor Corporation • 198 Champion Court	•	San Jose, CA 95134-1709	•	408-943-2600
Document Number: 001-07970 Rev. *D		Revised February 01, 2008

[+] Feedback