Installing the Cable Modem Using the USB Port
CAUTION! Be sure to read this entire User’s Manual from front to back in sequence before installing the
This chapter describes how to install the cable modem using the USB port. First you connect the hardware (cable modem and power adapter). You then install the software drivers and verify that the modem is operating properly.
The USB port does not support the Macintosh operating system.
Using the USB port to connect to the Internet enables you to install the cable modem more quickly and easily than connecting to the Internet using the computer’s Ethernet port, because you do not have to remove the case from the computer to install a network interface card (NIC). Using the USB port, however, enables you to connect only one computer to the cable modem.
See “Installing the Cable Modem Using the Ethernet Port” if you wish to install the cable modem using the Ethernet port.
Installing the Hardware (Cable Modem and Power Adapter)
To install the hardware:
WARNING! Risk of electric shock. Do not expose the cable modem to water or moisture.
1 Power off the computer (and television, if you plan to have the cable modem and television connected to the same wall cable outlet).
2 Unplug the computer (and television).
3 Connect the coaxial cable to the cable modem’s cable television (CATV) cable connector.
4 If you plan to have the cable modem and a television connected to the same wall outlet, you must use a cable line splitter (not included).
5 Connect one end of the included USB cable to the USB port on the cable modem and the other end of the cable to the USB port on the computer.
CAUTION! You must use the 12VDC/1.0A power adapter that comes with the
17
