D-Link DCS-1000W manual LED Control, Loading ActiveX From

The default setting for the Encryption Key is Disable. Therefore, to secure the wireless transmission be sure to Enable the Encryption Key by entering the relevant data.

Note:

Carefully input the Encryption Code, any error setting the code will cause the communication link to fail.

LED Control:

The LED control allows you to setup the LED illumination as desired. This feature provides the flexibility when surveillance activity is ON.

There are three options as follows:

ƒNormal

Power - Steady On of the LED indicator.

LAN/WLAN - Steady On of the LED indicator. When LAN/WLAN activity is present the LED indicator will flash steadily.

ƒOFF

Power - LED indicator is off

LAN/WLAN – LED indicator is off

ƒDummy

Power - Steady On of the LED indicator.

LAN/WLAN - Steady On of the LED indicator with random flashing.

Note: The WLAN LED is only available on the Wireless Internet Camera

The default setting for the LED control is Normal. When you have configured the LED control the correct illumination will set in after 1 minute.

Note:

This function is built-in to the LED indicators to add extra capabilities. The three options allow the Administrator to configure and camouflage the illumination for the LED indicator to falsify the monitoring status. In Normal Mode the LED indicator functions normally. Under Off Mode the LED indicators are both off, however, it is still monitoring the activity. In Dummy Mode the LED indicators operate in monitoring condition but monitoring activity is off or on.

Loading ActiveX From:

This field is used to specify the location of Xplug Control (ActiveX) plug-in program. Enter the information as required in .ocx format, for example: http://www.<your company>.com/xplug.ocx where <your company> must be replaced with your company’s DNS server.

22