D-Link DCS-1000W manual Using the Internet Camera as a Security System

Using the Internet Camera as a Security System

D-Link's IP Camera System is one of the most cost effect security solutions today. Both the DCS-1000 Wired model and DCS-1000W Wired/Wireless model have input/output controls for interfacing with security systems.

On the back of the Camera you will find an 8-position connector. This connector has 2 input triggers for security sensors and 2 output triggers for security alarms.

Security sensors for input are available as Passive (low- current/low voltage) sensors or Active (powered) sensors.

Because of power limitations of the DCS cameras and its compatibility with Power over Ethernet standards the sensor power requirement must be obeyed for proper operation. We have listed Passive and Active components that will interface with the DCS family of Cameras. Passive components must not exceed 5V 100mA. Active components must be self-powered by an external power source.

For the demonstration below a D-Link DCS-1000 was purchased from www.dlinkshop.com

,the security equipment was purchased from www.smarthome.com, and some cable accessories from a local hardware store.

Materials

•DCS-1000

•2 Ethernet Cables & Ethernet Switch/Internet Router

•An Ethernet based PC to configure system

•Internet Name Server and E-Mail Server to send capture information

•10FT. 24Gauge

•1 light current power distribution block for 12V power

•30W Weatherproof Siren

•High Sensitivity DPDT relay (allows 5V camera to turn on 12V siren)

•Mini-Magnetic Contact Switch (commonly used for doors or windows)

•PIR Motion Detector

You will need some simple tools like wire cutters/strippers and the appropriate screwdriver for mounting and distribution block setup.

Everything less the camera cost about $97 US Dollars including shipping.

11