D-Link DCS-910/90 manual Setup Wireless, Wireless Interface

Section 3 - Configuration

Setup > Wireless

In this section, you can setup and configure the wireless settings on your camera.

Note: Wireless is available only for the DCS-920.

Wireless Interface

SSID:

Channel:

Connection Mode:

Survey:

Wireless Security Mode:

WPA-PSK / WPA2PSK Settings:

Service Set Identifier, an identifier for your wireless network.

The default setting is channel 6. Select the same channel that is using by other wireless devices within your network. When there is interference from the wireless networks that overlap with one another, you may change the channel to obtain maximum performance for your connection.

Infrastructure is a wireless connection using an access point as a transmission point of all wireless devices. Ad-Hocis a wireless connection used without an access point, where your DCS-920 is directly connecting to your PC. This is done using the on- board wireless adapter on the DCS-920 connected to a wireless adapter on the PC.

This page will allow you to select a wireless network that the DCS-920 was able to detect upon booting up.

For security, there are three choices; None, WEP, and WPA-PSK /WPA2-PSK. Select the same encryption method that is being used by your wireless device/ router.

An appropriate Preshared Key, which is needed in order to connect to the wireless network..

D-Link DCS-910/920 User Manual 26