Configuration | D-Link DIR-825 manual

Section 3 - Configuration

If you selected PPPoE, enter your PPPoE username and password. Click Next to continue.

Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS server addresses.

Note: Make sure to remove your PPPoE software from your computer. The software is no longer needed and will not work through a router.

If you selected PPTP, enter your PPTP username and password. Click Next to continue.

If you selected L2TP, enter your L2TP username and password. Click Next to continue.

D-Link DIR-825 User Manual

16

Image 20

D-Link DIR-825 manual Configuration

Contents

Page Preface Manual RevisionsTrademarks Revision Date Description Table of Contents Wireless Security Registration ProductPackageOverviewContents System Requirements Computer with the followingBrowser Requirements Utility Requirements Introduction Total Performance Features Hardware Overview Connections Power LED LEDsInternet LED Status LED Installation Before you Begin Wireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Click Install Router Getting Started Configuration Web-based Configuration Utility Setup Wizard Click Launch Internet Connection Setup Wizard to begin Configuration Configuration Configuration Manual Internet Connection Setup Click Manual Internet Connection Setup to begin Dynamic Cable Host NamePrimary Server Connection Internet SetupPPPoE DSL Pptp ManualPage Reconnect Mode Select either Always-on,On-Demand, or Manual L2TPPage Static assigned by ISP Wireless Settings Manual Wireless Settings 802.11n/g 2.4GHzPage 802.11n/a 5GHz Page Network Settings Router Settings Dhcp Server Settings Dhcp Reservation Virtual Server Configuration Port Forwarding Application Rules QoS Engine SpeedPage Network Filters Access Control Access Control Wizard Access Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering Rule Inbound Filters Enable DMZ Firewall SettingsEnable SPI NAT Endpoint Filtering Routing Advanced Wireless Settings Transmit Power Set the transmit power of the antennas 802.11n/a 5GHz Wish Settings Page Wi-Fi Protected Setup WPS Reset PIN to Station Device Wizard Advanced Network Settings Enable UPnP WAN Ping Schedule Security ModeGuest Zone Administrator Settings Time Settings SysLog SysLog Server SysLog Server Email Settings Authentication authentication System Settings Update Firmware Check Email Notification of Newer Firmware Ddns System Check Schedules Device Information Log Statistics Internet Sessions Wireless Wish Support Wireless Security What is WPA? Wireless Security Setup Wizard Security Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Next to Security Mode, select WPA-Personal Configure WPA-Enterprise Radius Next to Security Mode, select WPA-Enterprise Security Connect to a Wireless Network Using Windows Vista Configure Wireless Security Connecting to a Wireless Network Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility? What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics What is Wireless? Wireless Local Area Network Wlan Small Office and Home Office Wireless Personal Area Network WpanHome Centralize your router or Access Point Eliminate Interference Wireless Modes Security Networking Basics Check your IP address Statically Assign an IP address Step Technical Specifications Contacting Technical Support For customers within the United States Warranty Limited Warranty Submitting a Claim Limited Software WarrantyNon-Applicability of Warranty What Is Not Covered Disclaimer of Other Warranties Limitation of Liability Governing LawTrademarks Copyright Statement CE Mark Warning FCC StatementFCC Caution FCC Radiation Exposure Statement Règlement d’Industry Canada ICC NoticeIC Radiation Exposure Statement Registration