D-Link DSL-504G manual Information you will need about your LAN or computer

DSL-504G ADSL Router User’s Guide

Information you will need about your DSL-504G ADSL Router:

	This is the Username needed access	the	Router’s	Record info here
Username	management interface. When you attempt to connect to the
	device through a web browser you will be prompted to enter
	this Username. The default Username for the Router is
	admin. This may be changed by the user.
Password	This is the Password you will be prompted to enter when you
	access the Router’s management interface. The default
	Password is admin. This may be changed by the user.
	This is the IP address you will enter into the Address field of
	your web browser to access the Router’s configuration
LAN IP addresses for the	graphical user interface (GUI) using a web	browser. The
	default IP address is 10.1.1.1. This may be changed to suit
DSL-504G
	any IP address scheme the user desires. This address will be
	the base IP address used for DHCP service on the LAN when
	DHCP is enabled.
LAN Subnet Mask for the	This is the subnet mask used by the DSL-504G, and will be
	used throughout your LAN. The default subnet		mask is
DSL-504G
	255.0.0.0. This can be changed later.

Information you will need about your LAN or computer:

	If your computer has an Ethernet NIC, you can connect the	Record info here
Ethernet NIC	DSL-504G to this Ethernet port using an Ethernet cable.
	You can also use the Ethernet port on the DSL-504G to
	connect to other Ethernet devices, such as a Wireless
	Access Point.
	Your DSL-504G ADSL Router is configured, by default, to
	be a DHCP server. This means that it can assign an IP
	address, subnet mask, and a default gateway address to
DHCP Client status	computers on your LAN. The default range of IP addresses
	the DSL-504G will assign are from 10.1.1.2 to 10.1.1.254.
	Your computer (or computers) needs to be configured to
	Obtain an IP address automatically (that is, they need to
	be configured as DHCP clients.)

Once you have the above information, you are ready to setup and configure your DSL-504G ADSL Router.

	The Router may be reset to its factory default settings by performing a Restore
	settings operation within the management interface. If you cannot gain access to
	the management interface, you may opt to use the Reset button on the rear panel of
Note
	the device.

3