20
3. Turn on the power of the DWL-810 by connecting one end of the
power adapter (included with your purchase) into the power port on
the DWL-810, and connecting the other end into the AC power outlet
on your wall.
4. The DWL-810 will automatically detect the MAC address of the
network device to which it is connected, and begin wireless
transmission to other wireless-enabled devices.
7. Troubleshooting
This section provides solutions to situations that can occur during the
installation and operation of the DWL-810 Ethernet-to-Wireless Bridge.
Read the following descriptions if you are having problems.
1. The DWL-810 Ethernet-to-Wireless Bridge Power light is not on.
• Check to see if the DWL-810 Ethernet-to-Wireless Bridge power
adapter is connected properly to a known good power outlet.
2. The DWL-810 Ethernet-to-Wireless Bridge Link light is not on.
• Make sure that the Ethernet cable is connected properly and your
Ethernet adapter supports 10BaseT.
Advanced Setup (optional)
For advanced setup features, enter http://192.168.0.30 into your
Internet browser and gain access to the web configuration of the
DWL-810. The advanced setup features can be used to change the
LAN and wireless settings for your DWL-810 Ethernet-to-Wireless
Bridge.
3. I cannot connect to another wireless client.
• The DWL-810 Ethernet-to-Wireless Bridge has a default SSID of
default. Make sure that the SSID on the DWL-810 Ethernet-to-
Wireless Bridge is exactly the same as the SSID on the other
wireless client.