5.Web Configuration

No Configuration is needed when you use the DWL-810 in Ad-Hoc Mode (Setup #1.)

Configuration is required only if you will be using the DWL-810 in Infrastructure mode. If you will be using the DWL-810 in Infrastructure mode or if you need to configure the DWL-810, please consider the following before using the Web Configuration:

You will need a JavaScript-enabled web-browser such as the Internet

Explorer 4.0 or higher, or the Netscape Navigator 4.0 or higher.

The computer that you are using for initial configuration must have an IP Address within the same range as the IP Address of the DWL-

810.The DWL-810 has a default IP Address of 192.168.0.30 with a subnet mask of 255.255.255.0

You will need to assign a Static IP Address to the computer that you are using to configure the DWL-810, within the IP Address Range of the DWL-

810.For example, you can assign a Static IP address of 192.168.0.2 with a subnet mask of 255.255.255.0 (Please refer to the Appendix section of the Quick Installation Guide.)

Factory Default Settings for the DWL-810

Operating Mode

Ad-Hoc

SSID

default

Channel

6

Transmission rates

Auto

WEP enable

No

Administrator password

Blank (no password needed)

IP Address mode

Static

IP Address

192.168.0.30

IP Subnet

255.255.255.0

username

admin (all lower case)

 

 

12

Page 12
Image 12
D-Link manual Web Configuration, Factory Default Settings for the DWL-810