To set new default settings from the control panel

1.Press the button next to Scan/Fax.

2.Press the button next to Fax Menu.

3.Press the button next to Fax Settings.

4.Make your changes to Resolution and Lighter/Darker.

5.Press the button next to the down arrow to highlight Set New Defaults, and then press the button next to OK.

For more information, see:

•“Change the fax resolution” on page 23

•“Change the Lighter/Darker setting” on page 24

Test your fax setup

You can test your fax setup to check the status of the HP All-in-One and to make sure it is set up properly for faxing. Perform this test after you have completed setting up the HP All-in-One for faxing. The test does the following:

•Tests the fax hardware

•Verifies the correct type of phone cord is connected to the HP All-in-One

•Checks that the phone cord is plugged into the correct port

•Checks for a dial tone

•Checks for an active phone line

•Tests the status of your phone line connection

The HP All-in-One prints a report with the results of the test. If the test fails, review the report for information on how to fix the problem and rerun the test.

To test your fax setup from the control panel

1.Set up the product for faxing according to your particular home or office setup instructions.

2.Insert the print cartridges and load full-size paper in the input tray before starting the test.

3.Press the button next to Scan/Fax.

4.Press the button next to Fax Menu.

5.Press the button next to Fax Setup.

6.Press the button next to the down arrow to highlight Run Fax Test, and then press the button next to OK.

The status of the test appears on the display. The product also prints a detailed report.

7.Review the report.

•If the test passes and you are still having problems faxing, check the fax settings listed in the report to verify the settings are correct. A blank or incorrect fax setting can cause problems faxing.

•If the test fails, review the report for more information on how to fix any problems found.

8.After you pick up the fax report, press the button next to OK. If necessary, resolve any problems found and rerun the test.

Finish setting up the HP All-in-One

Fax setup

25