Installation Instructions

Moving the Range to Final Location

1)Peel the protective plastic coating off of the range, including the range door.

2)Uncoil the power cord and route it to the electrical outlet so that it does not become trapped behind the range when it is pushed back. Do not connect the power plug until you are ready to verify proper operation.

3)Carefully slide the range into position taking the slack out of the power cord as you push the unit into place. Be careful not to kink the power cord or gas line as you push the unit back. The anti-tip foot should engage the anti-tip bracket as you slide it back.

Re-Installing the Door

WARNING

To avoid personal injury or damage to the door from it falling off its hinges:

• Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door.

• Rotate the hinge locks toward the front of the range immediately after installation of the door.

1) Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the oven. Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge receptacles.

2) Continue to hold the door at a 15° angle with one hand while pushing in on each of the bottom corners of the door. Push until the notch on the bottom of each hinge slips over the lower lip of each hinge receptacle.

3) Lower the door to the fully opened position.

4) Rotate the two hinge catches toward the oven. Slowly and carefully open and close the door completely to ensure that it is properly installed.

5) Remove any packaging from inside the oven.

Notch

Lower lip of hinge

receptacle

Door Installation

11