Installation Instructions

Backguard Kit Installation

See page 3 for available model numbers and compatibility.

If installing a backguard other than the standard size, install it before pushing the range into place. Install the kit according to the accompanying installation instructions.

Self-Rimming Trim Installation

The self-rimming trim kit is for use with model ER36GI with a self-rimming cutout and low profile (1 3/4”) backguard only. When installed, the kit accommodates countertop thicknesses up to 1 5/8”. Install the trim pieces and side panels before pushing the range into place. A T-20 Torx driver is required.

1)Locate the three (3) trim pieces, the two (2) self- rimming side panels and the fourteen (14) #8 x 1/4 Torx screws included with the range.

2)Remove and discard the six (6) screws that hold the backguard in place. DO NOT remove the three screws toward the center on the back. Slide the backguard up to remove.

DO NOT remove

three center screws

Back of Range

3)Remove and discard the screws (5 each) that hold the existing left and right trim pieces in place.

4)Slide the existing left and right trim pieces up and off the range.

5)Slide the provided left and right trim pieces onto the range. The overhang on each piece goes toward the back.

6)Fasten the new trim pieces in place using the provided #8 x 1/4 Torx screws (3 each side). IMPORTANT: To ensure proper fit of the range in the cutout, do not use the screws removed from the range in step 3. Use only the provided #8 x 1/4” Torx screws.

Overhang

7)If there is a countertop overhang to the rear of the range of 3/4” or greater, remove the center screw on the back of the backguard to allow attachment of the rear trim piece in step 8.

Rear of Backguard

Continued...

7