Installation Instructions
Verifying Proper Operation
WARNING
Before operating the range, read the accompanying use and care manual completely.
If the range does not operate properly, follow these troubleshooting steps:
1) | Verify that the circuit breaker for the range electrical |
| outlet is on and not tripped. Make sure the power cord |
| is connected. |
2) | Make sure the gas supply valve is in the on position |
1)Before beginning the test procedure, make sure all range control valves are in the “OFF” position, and all burner rings, burner cap and grates are properly positioned on the spill tray.
2)Turn on the gas supply at the
“OFF”
symbol on
knob
| and that the main gas valve to the building is open. |
3) | Check to see if the oven burner light flashes on and |
| off once a second. If it does, repair by an authorized |
| service technician is required. |
4) | Repeat the above tests. |
5) | If the appliance still does not work, contact Dacor |
| Distinctive Service at (877) |
3)Connect the power cord to the electrical outlet.
4)Test the left front burner on the cooktop by pushing in and turning the control knob counterclockwise to the HIGH position. The knob should light when in the “ON“ position. The igniter for the left front burner will spark
continuously. It may take up to 4 seconds for the burner to ignite, at which time the ignitor will stop sparking.
If ignition does not occur within 4 seconds, turn off the knob, wait for at least 5 minutes to allow any gas to dissipate, then repeat this ignition test. When the burner ignites, rotate the knob counterclockwise from
HIGH to LOW to adjust the |
|
flame height progressively. |
|
When installed properly, the |
|
flame will be steady. It will |
|
also have a sharp, blue inner |
|
cone that will vary in length |
|
proportional to the burner |
|
size. LP gas units may have |
|
small yellow tips at the end of | Normal Flame |
the flames, which is normal. |
5)Repeat the ignition test for
the remaining cooktop burners. Check to make sure the knobs light when in the “ON” position
6)After testing all the cooktop burners, turn them all off.
7)Open the oven door. Test the oven light by turning on the light switch on the right side of the control panel.
8)Turn on the convection fan switch. You should hear the convection fan, located behind the screen at the back of the oven, come on.
9)With the oven door open, turn the oven control knob to the 400 degree position. Both the knob itself and the oven ON indicator light next to the knob should illuminate. Within 60 seconds you should hear the bake burner ignite below the oven floor. It should begin to give off heat.
10)Turn the oven control knob to the BROIL position. The bake burner should turn off. Both the oven control knob and the oven ON indicator light should be illuminated.
Within 60 seconds the IR burner on the ceiling of the oven should ignite and begin to give off heat.
11)Turn the oven knob to the “OFF” position.
repair the appliance yourself. Dacor is not responsible |
for the cost of correcting problems caused by a faulty |
installation. |
Installation Checklist
WARNING
To ensure a safe and proper installation, the installer must perform the following checklist to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner.
□□ Has the plastic coating been peeled off of the outside of the range? Have all packaging materials been removed from inside the oven?
□□ Are all leveling legs extended down to make contact with the floor? Is the unit level? See page 8.
□□ Is the range secured in place with the provided
□□ Is the range connected to a grounded three prong electrical outlet that has been installed by a licensed electrician according to these instructions and in accordance with all applicable electrical codes? See pages 4 and 5.
□□ Is the backguard installed?
□□ Has the gas supply inlet pressure been measured to ensure that it does not exceed the maximums stated in these instructions? See page 4.
□□ Is the range connected to the gas supply according to these instructions and in accordance with all applicable codes? See pages 4 and 10.
□□ Did the installer check the gas supply for leaks?
□□ Is the oven door properly installed according to these instructions? See page 11.
□□ Are the burners and grates properly installed according to these instructions? See page 12.
□□ Has proper operation been verified?
□□ Has the warranty been activated
13