DMB-3003LH 2003.3.4 9:57 AM 페이지19

TROUBLESHOOTING GUIDE

Before requesting service, please refer to the chart below for possible solutions:

SYMPTOMS

POSSIBLE CAUSE

POSSIBLE SOLUTIONS

 

 

 

 

No power

.

Power failure.

Restore the power

 

 

 

 

 

 

Line voltage too low.

Contact electrician to install new outlet.

 

 

 

 

 

 

Unit is unplugged or not completely

Insert plug all the way.

 

 

plugged in.

 

 

 

 

 

 

 

Unit is off.

Turn unit on.

 

 

 

 

 

 

Batteries in remote are weak or dead.

Replace remote’s batteries.

 

 

 

 

 

 

EMERGENCY/REMOTE

Slide EMERGENCY/REMOTE

 

 

switch is not set to REMOTE.

to REMOTE.

 

 

 

The compressor does

When the unit is first plugged in

Wait 3 minutes for the unit to operate.

not turn on.

 

and turned on, the compressor

 

(no cool air)

 

will delay turn on for 3 minutes.

 

 

 

 

 

 

 

If the unit is turned off and then

Wait 3 minutes for the unit to operate.

 

 

immediately back on, the compressor

 

 

 

will delay for 3 minutes.

 

 

 

 

 

 

 

The air filter(s) is dirty or clogged.

Clean or replace filter(s).

 

 

 

 

 

 

Unit is located near a heat

When locating unit for the first time,

 

 

source (heater, stove, etc.)

make sure it is in a desirable location.

 

 

 

 

 

 

A door or window is open.

Shut door or window.

 

 

 

 

 

 

There is an obstacle in front of

Remove obstacle.

 

 

intake or indoor unit.

 

 

 

 

 

 

 

Thermostat is set too high.

Set thermostat lower.

 

 

 

Strange sounds occur.

During operation, especially after

This is normal.

 

 

turning it on or off, refrigerant flows

 

 

 

inside the unit.

 

 

 

 

Strange smells occur.

The fan is bringing out the

The smell should go away shortly.

 

 

smells of the carpet, walls, etc.

 

 

 

 

No remote operation.

Batteries are weak, dead or

Replace batteries.

 

 

inserted improperly.

 

 

 

 

 

 

 

Remote is out of range.

Move closer to unit.

 

 

 

 

 

 

Remote not aimed at sensor.

Aim remote at sensor.

 

 

 

 

 

 

There is an obstruction between

Remove obstruction.

 

 

unit and remote.

 

 

 

 

 

S/N.: 3113910500

19

Page 20
Image 20
Daewoo DMB-3003LH owner manual Troubleshooting Guide, Symptoms Possible Cause Possible Solutions