JVC RX-884PBK manual Troubleshooting, English, Problem, Possible Cause, Solution

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.

PROBLEM		POSSIBLE CAUSE		SOLUTION
The display does not light up.	The power cord is not plugged in or the		Plug the power cord into an AC
		POWER switch pressed to set it in the	outlet and/or press		POWER to
	ÑOFF position.		set it in the _ON position.
No sound from speakers.	Speaker signal cables are not connected.		Check speaker wiring and
			reconnect if necessary.
	The SPEAKERS 1 and 2 buttons are not		Press SPEAKERS 1 and 2 correctly.
	set correctly.
	An incorrect source is selected.		Select the correct source.
	Muting is activated.		Press MUTE to cancel the mute.
Sound from one speaker only.	Speaker signal cables are not connected		Check speaker wiring and reconnect
	properly.		if necessary.
	The balance is set to one extreme.		Adjust the balance properly (see
			page 19).
Continuous hiss or buzzing during FM	Incoming signal is too weak.		Connect an outside FM antenna or
reception.			contact your dealer.
	The station is too far away.		Select a new station.
	An incorrect antenna is used.		Check with your dealer to be sure
			you have the correct antenna.
	Antennas are not connected properly.		Check connections.
Occasional cracking noise during FM	Ignition noise from automobiles.		Move the antenna farther from
reception.			automobile traffic.
No color on the on-screen display.	The color system of the connected TV is		Connect a PAL TV.
	not PAL
Howling during record playing.	Your turntable is too close to speakers.		Move speakers away from the
			turntable.
“OVERLOAD” starts flashing on the	Speakers are overloaded because of high		Rotate the MASTER VOLUME
display.	volume.		control counterclockwise three or
			four times, then press STANDBY/
			ON	on the front panel.
			If “OVERLOAD” does not
			disappear, unplug the AC power
			cord, then plug it back again.
	Speakers are overloaded because of short		Press STANDBY/ON			on the
	circuit of speaker terminals.		front panel, then check the speaker
			wiring.
			If “OVERLOAD” does not
			disappear, unplug the AC power
			cord, then plug it back again.
			If speaker wiring is not short-
			circuited, contact your dealer.
Remote control does not work.	The remote control mode selector is not set		Set the selector correctly either to
	correctly.		“AUDIO/TV/VCR” or to “CATV/
			DBS.”
	There is an obstruction in front of the		Remove the obstruction.
	remote sensor on the receiver.
	Batteries are weak.		Replace batteries.

English

66