JVC RX-884PBK English, On the front panel, Using the DAP Modes, Theater, 3D THEATER, 3D DRAMA

Using the DAP Modes

You can use five DAP modes — “Live Club, Dance Club, Hall, Pavilion, and Headphones” for any source.

Among the DAP modes, “Headphones” is very special. It can create the same stereo sound as you listen through the speakers off air while listening to a source using headphones. So, you can feel as if you were not using the headphones and listening to music in a room.

If the digital input is selected to play the source encoded with Dolby Digital, you can only select “Headphones.”

On the front panel:

DSP MODE

1.Press DSP MODE.

The current DSP mode appears on the display.

2.Turn MULTI JOG until the mode (LIVE CLUB, DANCE

MULTI JOG

CLUB, HALL, PAVILION, or HEADPHONE) you want appears on the display, while the indication of the previous step is still on the display.

The DSP indicator also lights up on the display.

As you turn it, the DSP modes change as follows:

		THEATER		LIVE CLUB		DANCE CLUB		HALL
DSP OFF								PAVILION
	3D THEATER		3D DRAMA		3D ACTION		HEADPHONE

When the digital input is selected to play the source encoded with Dolby Digital:

DIG-THEATERHEADPHONE

DSP OFF 3D DIGITAL

LIVE CLUB:	Gives the feeling of a live music club with a low ceiling.
DANCE CLUB:	Gives a throbbing bass beat.
HALL:	Gives clear vocal and the feeling of a concert hall.
PAVILION:	Gives the spacious feeling of a pavilion with a high ceiling.
HEADPHONE:	Gives a spacious stereo effect when listening with headphones.
DSP OFF:	No DSP mode is applied.

For the other modes, see pages 31 and 39.

If you need to make any adjustment, go to the following steps.

English

Notes:

•The DAP mode is not used with the other DSP modes such as the 3D-PHONIC mode and the Surround mode. When the DAP mode is turned on, the other DSP mode, if used, will be turned off.

•When the DAP mode is used with the SEA mode (see page 28), sounds may be distorted. If this happens, turn off the SEA mode.

Note:

The indicator of the selected DSP mode also lights up on the display while selecting.

Note:

When you select “HEADPHONE,” you cannot go to the following steps. No adjustments can be made for “HEADPHONE.”

3.Adjust the speaker output levels as follows.

1)Press BALANCE/SURROUND ADJUST repeatedly until one of the indications appears on the display. “REAR L LEVEL”: To adjust the left speaker level. “REAR R LEVEL”: To adjust the right speaker level.

2)Turn MULTI JOG to adjust the selected speaker output level (from –10 dB to +10 dB), while the indication of the previous step is still on the display.

3)Repeat 1) and 2) to adjust the other speaker output levels.

BALANCE/SURROUND

ADJUST

MULTI JOG

Note:

You cannot adjust the rear speaker levels when “REAR SPK” is set to “NONE” (see page 20).

Continued to the next page.

34