Using the DSP Modes
English
On the front panel:
You can also use the buttons on the front panel to adjust the Theater Surround mode. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.
1. Select and play the source encoded with Dolby Digital (bearing the mark
) or with Dolby Surround (bearing the mark |
|
| DOLBY SURROUND | ). |
D I G I T A L
•When you play back the source encoded with Dolby Digital and select the digital input for that source, the Ù DIGITAL indicator lights up on the display.
Notes:
• | To enjoy the software encoded |
| with Dolby Digital, you must |
| connect the source |
| component using the digital |
| terminal on the rear of this |
| receiver. |
• | The Surround mode is not |
| used with the other DSP |
| modes such as the DAP mode |
2.Press DSP MODE.
The current DSP mode appears on the display.
3.Turn MULTI JOG until “THEATER” or “DIG- THEATER” appears on the display, while the indication of the previous step is still on the display.
The DSP and THEATER indicators also light up on the display.
DSP MODE
MULTI JOG
and |
the Surround mode is turned |
on, the other DSP mode, if |
used, will be turned off. |
Notes on the indications:
As you turn it, the DSP modes change as follows:
When the digital input is selected to play the source encoded with Dolby Digital:
DSP OFF 3D DIGITAL
For other sources:
THEATER LIVE CLUB DANCE CLUB HALL
DSP OFF |
| PAVILION | ||||||||
|
| 3D THEATER |
| 3D DRAMA |
| 3D ACTION |
| HEADPHONE |
|
|
|
|
|
|
|
|
|
If you need to make any adjustment, go to the following steps.
•The PRO LOGIC indicator lights up when the Dolby Pro Logic decoder built in this receiver is activated.
•The Dolby Pro Logic decoder is used not only for the analog sources but also for the sources encoded with Dolby Digital in the following cases:
–When only front channel signals are encoded.
–When front channel and monaural rear channel
signals are encoded. While the Dolby Pro Logic is activated for this type of Dolby Digital source, the Ù DIGITAL indicator goes off.
4.Adjust the speaker output levels as follows.
1)Press BALANCE/SURROUND ADJUST repeatedly until one of the indications appears on the display. “CENTER LEVEL”: To adjust the center speaker level. “REAR L LEVEL”: To adjust the left speaker level. “REAR R LEVEL”: To adjust the right speaker level.
2)Turn MULTI JOG to adjust the selected speaker output level (from
3)Repeat 1) and 2) to adjust the other speaker output levels.
BALANCE/SURROUND
ADJUST
MULTI JOG
Notes:
•You cannot adjust the center speaker level when “CENTER SPK” is set to “NONE” (see page 20).
•You cannot adjust the rear speaker levels when “REAR SPK” is set to “NONE” (see page 20).
41