Selecting the Front Speakers
On the front panel only:
SPEAKERS
12
When you have connected two pairs of the front speakers, you can select which to use.
Press SPEAKERS 1 or SPEAKERS 2 to select the speaker to use.
Each time you press the button, the lamp on the respective button turns on and off. When the lamp on either button lights up, the respective speakers are activated.
IMPORTANT:
You can activate two pairs of the front speakers at the same time only when no signals are sent to the center and rear speakers. Otherwise, activating one pair of the speakers deactivates the other.
Listening only with headphones
1.Connect a pair of headphones to the PHONES jack on the front panel.
2.Press SPEAKERS 1 and/or 2 so that no lamps on the buttons are turned on.
Muting the Sound
From the remote control only:
Press MUTE to mute the sound through all speakers and headphones connected.
“MUTE” appears on the display and the volume turns off (the volume level indicator also goes off).
To restore the sound, press MUTE again so that “OFF” appears on the display. Turning MASTER VOLUME or pressing VOLUME +/– also restores the sound at the previous volume level.
Recording a Source
You can record any source playing through the receiver to the cassette deck or the MD recorder connected to the TAPE/MD jacks and the VCRs connected to the VCR1 and VCR2 jacks at the same time.
While recording, you can listen to the selected sound source at whatever sound level you like, without affecting the sound levels of the recording.
English
Note:
If you use any of the DSP modes other than the 3D- PHONIC modes and “HEADPHONE” with both front speakers activated, the speakers connected to the
FRONT SPEAKERS 2 terminals are deactivated.
CAUTION:
Be sure to turn down the volume before connecting or putting on headphones, as high volume can damage both the headphones and your hearing.
Note:
You cannot shut off the sound through the subwoofer using the SPEAKERS 1 and 2 buttons.
Note:
The output volume level and SEA modes cannot affect the recording.
IMPORTANT:
When recording the digital source, turn off the DSP mode.
16
