6
4. DIRECTIONS FOR INSTALLATION AND USE
DIRECTIONS
The opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
§§

Location Of Washer

Check location where washer will be installed. Make sure you have everything necessary for correct installation.
Proper installation is your responsibility.
• Do not place or store your washer below 0˚C(32˚F) to avoid any damage from freezing.
• Install the washer on the horizontal sold foor.
NOTES
If the washer is installed on an unsuitable floor, it could make consider-
able noise, vibrate and cause a malfunction.
If washer is not level, adjust the front leg(A) up or down for horizontal set-
ting.
• Earthed electrical outlet(B) is required with 20cm of bottom back of
washer cabinet.
• Hot and cold water faucets (C) must be within 1M of the upper back of
the washer cabinet and provide water pressure 0.3kgf/cm2-
8kgf/cm2(2.94N/cm2-78.4N/cm2).
§§

Drain System

Never forget to install drain hose before operating your washer.
The packing box is opened, there are a drain hose.
• Conect the drain hose to the drain outlet at the back side of the washer.
Non-Pump Model Pump Model
1In case that it goes over a door sill.
Don’t let the height of the drain
hose exceed 20cm from the bottom
of washer.
2In case of extending the drain hose.
Don’t let the total length exceed 3m. 3Be careful that the end of the drain
hose is not immersed in water.
Non-Pump Model
• Top of tub must be at
least 86cm (34inches)
high and no higher than
130cm from bottom of
washer (A)
• Needs a 3cm minimum diameter standpipe with minimum
carry away capacity of 30liters per minute.
• Top of tub must be at
least 86cm(34inches)
high and no higher than
130cm from bottom of
washer (B)
Pump Model
Laundry tub drain system Standpipe drain system
C
UP DOWN
B
A
Drain hose
Drain Outlet
Drain hose
20Cm
3m
A
B