Installation
Tools needed: Small Phillips Screwdriver;
Large Phillips Screwdriver; Small Standard Screwdriver.
Set Up:
1.Set PIR and
2.Install battery in PIR sensor (Figure 1 - 2) and mount at desired location. (Note: recommended to replace batteries every
6months.)
Figure 1
1
2
3.Plug the supplied phone cord into the “LINE” jack (Figure
4.(Note: please read all of step 4 before continuing). Remove the battery insulator by pulling the tab on the keyfob. Plug the DC adaptor into the dialer (Figure 2 - 3) and plug into wall outlet. Wait 20 seconds. You now have 30 seconds to teach the dialer. Press the RECORD button (Figure 3 - 3) on the dialer and the display will show “learning 0.” Press any key on the RF Keyfob. The display will
then show “learning 1” followed by a BEEP to confirm that it has learned the first keyfob. You then have another 30 seconds to teach it another keyfob (“learning 2”) and so on up to 5 keyfobs.
4
10/15/2009 10:17:55 AM