PIR settings: Loosen the phillips screw on the bottom of the case and swivel the top cover up to reveal the PIR board (figure 1). (The screw is captured in the case and will not come completely out.) The jumper settings are as follows:
Detection Range: High - 40 feet Medium - 25 feet Low - 12 feet
LED:ON - led will flash when it detects OFF - led is always dark
Filter:ON - set for outdoor use OFF - set for indoor use
Reset:15 seconds to reset after activation 120 seconds to reset after activation
Dip Switches: 1 & 2 should both be OFF (on the PIR board)
Coding the transmitter:
Note: The transmitter and receiver frequencies are preset
at the factory. DO NOT change settings, unless changingFigure 2 the tune or experiencing false signals.
1.Just above the PIR board is a small clip on the case. Pull on this clip and the center portion of the case will swivel down to reveal the radio transmitter and battery slot (figure 2).
3.
