Danby DAC14004D, DAC8404DE, DAC12344DE Removing Excess Humidity, Remote Control Control Panel

Removing Excess Humidity

If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much.

Remote Control Control Panel	1 If necessary, press the		(On/Off) button.
	Result:	The air conditioner starts up in the Cool mode.
		The unit beeps.
		The air conditioner is fitted with a protection mechanism to pre-
		vent the unit from being damaged when it is started immediately
		after being:
		Plugged in
		Stopped
		It will start up normally after three minutes.

2If the temperature is not displayed at the top of the control panel, press

the Cool/Dry/Fan		button on the control panel one or more times until it
	Mode
appears.		The unit beeps each time you press the Cool/Dry/Fan button.
Result:
			Mode
		The air conditioner runs in Dry mode.
		You can change modes at any time.

3 To adjust the temperature, press the or buttons one or more times until the required temperature is displayed.

Possible temperatures are between 18C and 30C inclusive.

Result: Each time you press the or buttons:

- The temperature is adjusted by 1C - The unit beeps

The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically.

4To control the direction of the air flow, refer to page 11.

E-10